Quit, Ctrl-x-enter, Help – Verilink XEL XSP-100 SHARK IAP (9SA-USRS-9.0R1.02) Product Manual User Manual
Page 145: Xcon module, Xc2t module, Module designations and keywords tree, Up -29 top -29 quit -29 ctrl-x-enter -29 help -29, Xcon module -29 xc2t module -29

Chapter 6: Using the Command Line Interface (CLI)
SHARK™ IAD User’s Guide
XEL P/N & Release 9SA-USRS-9.0R1.02
Chapter 6-29
UP
Move up the tree one node.
TOP
Move to the top node of the tree.
QUIT
You exit the configurator by typing quit from the from any where in the
configurator
CTRL-X-ENTER
To exit from within the stepping mode of the configurator press the CTRL and X
key at the same time. Then press the return or enter key.
HELP
The help command lets you display on-line help for ROOT and CONFIG
commands. To display a list of the commands available from your current
location in the command line interface hierarchy, enter help. To obtain help for
a specific CLI command, type help
command to he or a question mark ? when you request help for a CLI command.
This is part of the resulting display when ? is entered at the configurator's top
node (depending on the configuration, some items may not displayed):
XCON
MODULE
(top)>> ?
set --- set configuration data
view --- view configuration data
script --- print configuration setup script
save --- save configuration data
valid --- check if configuration data is valid
up --- move up the tree
top --- move to the top of the tree
help --- print this information
quit --- exit from configuration mode
Note: To exit from within the step configurator press CNTL-X-ENTER
ROUTER --- Configure router module parameters
TIMING --- Configure system timing parameters
VOICE-SYS --- Configure system voice parameters
LAN-1 --- Configure LAN module parameters
LAN-2 --- Configure LAN module parameters
WAN-1 --- Configure WAN module parameters
WAN-2 --- Configure WAN module parameters
XCON-1 --- Configure cross-connect module parameters
XCON-2 --- Configure cross-connect module parameters
trunk --- Configure trunk processing parameters
VOICE-1 --- Configure voice module parameters
VOICE-2 --- Configure voice module parameters
VOICE-3 --- Configure voice module parameters
(top)>>
XC2T MODULE
(top)>> ?
set --- set configuration data
view --- view configuration data
script --- print configuration setup script
save --- save configuration data
valid --- check if configuration data is valid
up --- move up the tree
top --- move to the top of the tree
help --- print this information
quit --- exit from configuration mode
Note: To exit from within the step configurator press CNTL-X-ENTER