Verilink XEL XSP-100 SHARK IAP (9SA-USRS-9.0R1.02) Product Manual - Manual (Page 92)

Chapter 5: Graphical User Interface (GUI/WEB) Configuration Pages
Chapter 5-38 XEL P/N & Release: 9SA-USRS-9.0R1.02 SHARK™ IAD User's Guide
Channel 1 Setup
Select the encapsulation (frame mode) and
the bandwidth (in 64kb/s slots) used by
TDM Channel 1
Frame Mode
Slot Assignments
Slot Start: Slot End:
1 4
frame-relay
Save
Click on the arrow to
select from these
additional options
frame-relay
off
frame relay
ppp
hdlc
frame-relay
Figure 34: Defining TDM Channel Bandwidth & Encapsulation
Encapsulation Once the encapsulation and slot assignments are saved the SHARK™ IAD TDM
configurator automatically accesses the remaining pages that are specific for the
selected encapsulation. Table 10,
Table 11 and Table 12 lists the paragraphs to follow for each type of
encapsulation chosen above.
Table 10 identifies the pages and paragraphs that describe the options that must
be configured when Frame-Relay encapsulation is chosen.
Table 11 identifies the pages and paragraphs that describe the options that must
be configured when PPP encapsulation is chosen. Table 12 identifies the pages
and paragraphs that describe the options that must be configured when HDLC
encapsulation is chosen.
Table 10: SHARK™ IAD manual paragraphs and figures for a TDM frame relay configuration
Pages Paragraphs Figures
5-39 TDM VCC enabling
and LMI selection
(Frame Relay
Encapsulation) Figure 35: Defining TDM VCC LMI protocol (Frame Relay
Encapsulation)
5-40 TDM VCC Type
selection
(Frame Relay
Encapsulation) Figure 36: TDM Channel VCC Setup (Frame Relay
Encapsulation)
Table 11: SHARK™ IAD manual paragraphs and figures for a TDM PPP configuration
Pages Paragraphs Figures
5-41 PPP Configuration
Page Figure 37: TDM VCC PPP enable page (PPP Encapsulation)
5-41 PPP Channel Select
Page Figure 38: The PPP Configuration Page