Library install, Library path, Library slot – Verilink XEL XSP-100 SHARK IAP (9SA-USRS-9.0R1.02) Product Manual User Manual
Page 129: Library uninstall, Library view

Chapter 6: Using the Command Line Interface (CLI)
SHARK™ IAD User’s Guide
XEL P/N & Release 9SA-USRS-9.0R1.02
Chapter 6-13
address is specified, then the current address is displayed.
LIBRARY INSTALL
library install [
Use this command to install new firmware from a TFTP server or by using
Xmodem protocal on the Craft Port. The protocal option of IP uses a TFTP
server running on the computer where the file for downloading is stored. The
server address and path are set with the commands:
library address (sets server ip address)
library path (sets default path).
If
The Xmodem potocal is only available on the Craft port. An attempt to use
Xmodem on a Telnet session will result in an error message.
LIBRARY PATH
library path [
to be use for library installations. If no path is specified, then the current path is
displayed. The path should include a trailing slash when specifying a directory:
library path /public/shark/download/
The path may contain both forward and backward slashes for compatibility with
other TFTP servers on operating systems. Note: If your TFTP server has a
problem with either / or \ in a path string, then use ./ as the path string. In
your TFTP server directory, specify the directory where the file is located,
and make that the base directory of the TFTP server.
LIBRARY SLOT
Library slot Use this command to list the available devices to be used in the
library install; uninstall, and view commands. This command does not have
arguments or parameters. The library commands use the following slot mappings
which is displayed when this command is entered:
1 VOICE1
2 Xconnect
3 Router
4
5 VOICE2
6 WAN1
7 LAN1
8
9 VOICE3
10 WAN2
11 LAN2
12
P
O
W
E
R
LIBRARY UNINSTALL
library uninstall
Use this command to remove the latest installed firmware image from the library
and revert to the previous version.
LIBRARY VIEW
library view [
'all' displays all current and backup information
'details' displays all data rather then default summary information
Use this command to view information about all firmware modules on file.