Gasboy Atlas Start-up - Manual (Page 95)

MDE-4334D Atlas™ Start-up and Service Manual · July 2013 Page 5-35
Installing Atlas 9800 Pulse-out I/F with EM Totalizer Drive Board (M06587A001) Electronic and Electrical Components
When configured for Dual Channel, Dual Hose Pulse-out I/F, the P3 connector is used.
Jumpers JP4 and JP5
When this board is used in a model A or Q pump/dispenser or 9850K, jumpers JP4 and JP5 are
set to the Q/A position. When this board is used for all other K models except 9850K, these
jumpers must be in the K position.
Configurations
Refer to Figure 5-26 through Figure 5-29 on page 5-36 for different configurations.
Figure 5-26: Dual Channel, Single Hose Pulse-out I/F
Pulse Side 1
Side 1B Output (Green)
Side 1A Output (Red)
Side 1A Return (Black)
Side 1A Return (White)
Jumper Settings
Single Channel, Dual/Single
Hose Pulse-out I/F
(Default Setting)
Dual Channel, Single Hose
Pulse-out I/F Dual Channel, Dual Hose
Pulse-out I/F
Wire Color JP1 Position 1
JP2 Position 1
JP3 Open JP1 Position 2
JP2 Position 2
JP3 Open JP1 Position 2
JP2 Position 2
JP3 Jumpered
Black No Connection Side 1B Return Side B Return
Blue** No Connection No Connection Pulse Out Side 2A*
Brown No Connection No Connection Pulse out Side 2A
Gray No Connection No Connection Side 2B Return
Green Pulse out Side 2 Pulse out Side 1B Pulse out Side 1B
Amber No Connection No Connection Pulse out Side 2B
Red Pulse out Side 1 Pulse out Side 1A Pulse out Side 1A
Violet** No Connection No Connection Pulse Out Side 2B*
White Common Return Side 1A Return Side A Return
Yellow No Connection No Connection Side 2A Return
*Requires DC conduit M05683A004 Revision B or later.
**9850K models only.