Gasboy Atlas Start-up - Manual (Page 54)

Page 4-22 MDE-4334D Atlas™ Start-up and Service Manual · July 2013
Pump Programming Programming 8800 Series Units
Command Code 11: Grade Assignment (Perform this at Console)
Assigning Grades. Normally not used as grades must be programmed using the POS.
Command Code 12: Pump Program
This is also a multi-purpose code with sub-codes. Not all codes are used for Atlas. If
accessible, do not change other codes from their default value or the pump/dispenser may not
work properly.
To program the pump, proceed as follows:
1 Press 12.
2 Enter the Side #, where 1 = Side A, 2 = Side B.
3 Enter the Function Code (1-4).
4 Enter the Configuration Code.
Function Code 1: Two-wire Pump ID
Sets the two-wire ID that the POS uses for the pump/dispenser involved. Press Enter after
making selections.
1-16 = Choose a number between 1-16
Function Code 2: Cash/Credit at Pump
0 = No
2 = Yes
Function Code 3: Side Exists
0 = Does not exist
1 = Exists
Function Code 4: PPU Options
0 = Level 1 price bar displays the level sent by console
1 = Normal
Level 3 Programming
You must enter Level 1 and 2 before accessing Level 3 commands.
• Level 1 - Press Fl, enter the 4-digit ID (default 2222), and then press Enter.
• Level 2 - From Level 1, enter any Level 2 Command Code (10-12), enter the 4-digit ID
(default 1503), and then press Enter.
• Level 3 - From Level 2, enter any Level 3 Command Code (13-17), enter the 4-digit ID
(default 1309), and then press Enter. Press F1 to exit any command code. Press F2 to
return to normal operation.
Command Code 13: PIN Code Change
Change PIN code. To change the PIN code, proceed as follows:
1 Enter 13.
2 Enter Level #1, 2, or 3.
3 Enter the new PIN code.
Note: The unit returns to Command Input Mode.