Gasboy Atlas Start-up - Manual (Page 94)

Page 5-34 MDE-4334D Atlas™ Start-up and Service Manual · July 2013
Electronic and Electrical Components Installing Atlas 9800 Pulse-out I/F with EM Totalizer Drive Board (M06587A001)
11 Apply power to the pump/dispenser and take note of the display(s). The first set of numbers
displayed will be the software version (for example, 06013), second set is the software type
(for example, 9800 1), and third set is the firmware version (for example, 01008).
Ensure that the displayed software type is correct for the pump/dispenser model that the CPU
is installed in (refer to the following table). If it is, proceed to step
12 . If not, proceed to
“Loading New CPU Software (M06333KXXXX)” on page 5-26 .
12 Reassemble the pump/dispenser by proceeding to “Accessing Electronic Components” on
page 5-31 and follow the steps in the reverse order.
Installing Atlas 9800 Pulse-out I/F with EM Totalizer Drive
Board (M06587A001)
Jumpers JP1, JP2, and JP3
This board assembly can be configured for use in one of the following pump/dispenser
configurations:
• Dual Channel, Single Hose Pulse-out I/F (see Figure 5-26 on page 5-35 ).
• Single Channel, Dual/Single Hose Pulse-out I/F (see Figure 5-27 on page 5-36 ).
• Dual Channel, Dual Hose Pulse-out I/F (see Figure 5-28 on page 5-36 ).
Following chart shows the jumper settings and wires to connect to in the J-box, based on the
configuration.
Check JP1 - JP3 jumpers and change them, if required. The jumper settings must be changed
only when the power to the pump/dispenser is removed, to protect the circuit that they are
connected to.
The default configuration is Single Channel, Dual/Single Hose Pulse-out I/F. When configured
for Dual Channel, Single Hose Pulse-out I/F, or Single Channel, Dual/Single Hose Pulse-out

I/F, the P3 connector is not connected.
Displayed Software Type Corresponding Pump/Dispenser Model
“9800 1” Corresponds to the 9800Q Software:
9852A/Q, 9853A/Q, 9822A/Q, 9823A/Q/K
“9800 2” Corresponds to the 9800K Software:
9852K, 9853K, 9862KX, 9872KX
“9840 1” Corresponds to the 9840Q Software:
9840A, 9840Q
“9840 2” Corresponds to the 9840K Software:
9840K
“9850” Corresponds to all 9850 Software:
9850A, 9850Q, 9850K