Gasboy Atlas Start-up - Manual (Page 46)

Page 4-14 MDE-4334D Atlas™ Start-up and Service Manual · July 2013
Pump Programming Programming 8800 Series Units
Display Conventions
The programming digit positions for the main money and volume displays are shown in

Figure 4-9 . This applies even in cases where more than six display digits are available for
display purposes. Information will be displayed on all grade PPUs when required and will be
restricted to digits 4 through 1, unless otherwise noted.
Figure 4-9: Location of Data on Displays at Power Up
During programming, the command code is always shown left justified in the main money
display, starting at digit position 6. Other display information will be dependent on specific
programming command codes and function codes within the command code.
Flashing fields indicate a selected parameter where data may be entered or simply inspected.
Programming parameters are shown in LCD displays as soon as the parameter selection key is
pressed. Parameters are entered into the pump control system only after Enter is pressed.
Totals Examples
To toggle between the grade and side selection for both $ Total and Vol Total key, press Enter
as found on the Manager Keypad.
Non-resettable Money and Volume Totals
The dispenser maintains a set of non-resettable totals for each dispensed fuel grade. These
totals reflect the total value of money and volume of fuel, since the dispenser was installed.
Money and Volume Totals
$ Total is used to retrieve money totals for each fuel grade. This key does not require a
security code. Clear is used to exit Money Totals mode. 1 displayed in the leftmost $ Total
display indicates that this total is a non-resettable money total. The Vol Total key displays the
volume for the grade selected. Volume for both sides of the unit can be viewed. Clear is used
to exit the Volume Total mode. This convention comes from The Advantage Series product
line and is maintained here for ASC and Site Manager familiarity.