Replacing cylinder cover and gasket, Cylinder cover leaks), Gasboy does not recommend – Gasboy Atlas Start-up User Manual
Page 149
MDE-4334D Atlas™ Start-up and Service Manual · July 2013
Page 6-29
Meters
Hydraulic/Mechanical Components
After Repairing Meters
After the repair is complete, proceed as follows:
1
Open shear valves (dispensers only).
2
Restore power to the unit and STP. In D-Box, place the unit in normal operation.
3
Purge air and check for leaks. Refer to
4
Calibrate the meter.
Replacing Cylinder Cover and Gasket (Cylinder Cover Leaks)
Note: Cork gaskets may show some staining. Replace the gaskets only when you note
dampness or pooling of fuel.
To replace the cylinder cover and gasket, proceed as follows:
1
Follow steps
.
2
Remove the cylinder cover.
3
Scrape the old gasket and clean the surface.
4
Install the new gasket. Replace the cylinder cover.
5
Torque all bolts in sequence as shown in
.
Figure 6-14: Replacing Cylinder Cover and Gasket
1st
2nd
3rd
4th
5th
6th
Cylinder Cover Gasket
Cylinder Cover
6
Follow the steps in