Gasboy Atlas Start-up User Manual
Page 159
MDE-4334D Atlas™ Start-up and Service Manual · July 2013
Page 6-39
Filters and Strainers
Hydraulic/Mechanical Components
To remove the filters, proceed as follows:
1
Slowly turn the filter counterclockwise. Use a filter wrench to loosen the filter, if required.
2
Drain the removed filter into an approved container and dispose of properly. Do not dispose of
filters and fuel soaked absorbent materials in trash cans. Follow local, state, and national code
requirements for disposal. Use of a fuel catch-cup or pan is recommended.
3
Remove and clean the strainer. Refer to
on
Installing New Filters
To install the new filters, proceed as follows:
1
Read and follow the instructions printed on the new filter.
Figure 6-21: Coating Filter Gasket
Strainer
Filter and
Gasket
Manifold
Apply Oil to Gasket
2
Install a cleaned or new strainer, inserting the cupped side into the filter manifold. Ensure that
it is fully inserted.
3
Coat the new filter gasket with a thin film of clean oil as shown in
on
4
Attach the filter to the hydraulic manifold and turn the filter clockwise until the gasket
contacts the base. Then, hand-tighten an additional half turn.
5
Restore power to the unit.
6
Open the shear valve on dispensers.
7
Lift the nozzle hook and authorize the pump.
8
Check for leaks.
9
Bleed air by dispensing 10 gallons (40 liters) into an approved container for each hose
involved.
10
Check for leaks again.