Gasboy Atlas Start-up - Manual (Page 29)

MDE-4334D Atlas™ Start-up and Service Manual · July 2013 Page 3-1
Introduction Start-up Procedures
3 – Start-up Procedures
Introduction
Purpose
Gasboy Atlas units require this start-up process for pumps and dispensers that are installed in
the United States. This procedure ensures that the equipment is installed and warranty is
registered properly. It is also recommended that you follow this procedure outside the United
States.
The start-up process and checklists are used to ensure that the unit(s) are installed and function
properly.
Important Information About Releases
Sections of this manual may be released or updated independently to supply the most current
data. Information about release date and version for independently released sections will be
included in the section title and footer of the document. For the latest updates, refer to GOLD.
This section was last updated in July 2013.
Topics in This Section
Topic Page
Certificate of Conformance (CoC) Numbers 3-1
Start-up Checklists 3-2
Meter Calibration 3-4
How to Use This Section
Make copies of the installation checklist found in MDE-4331 Atlas Fuel Systems Installation
Manual to ensure that all units have been installed correctly and function properly.
Certificate of Conformance (CoC) Numbers
CoC numbers are required during installation and start-up of new sites. You may be asked for
these numbers by a W&M official. For information on CoC numbers, refer to the cover page
of this document.