Delta Electronics AC Motor Drive VFD-VE Series - Manual (Page 74)

Chapter 4 Parameters|
Revision August 2008, 03VE, SW V2.04 4-25
Group 11 Advanced Parameters
Pr. Explanation Settings
Factory
Setting
VF VFPG SVC FOCPG TQRPG
11-00 System Control
bit 0: ASR Auto tuning
bit 1: Inertia estimate (only for FOCPG mode)
bit 2: Zero Servo
bit 3: Reserved
bit 4: Enable gain adjustment of position loop KP 0 ○
11-01
Per Unit of System
Inertia 1~65535 (256=1PU) 400 ○ ○
11-02 Low-speed Bandwidth 0~40Hz 10 ○ ○ ○
11-03 High-speed Bandwidth 0~40Hz 10 ○ ○ ○
11-04 PDFF Gain Value 0~200% 30 ○
11-05
Gain Value of Flux
Weakening Curve for
Motor 1 0~200% 90 ○ ○
11-06
Gain Value of Flux
Weakening Curve for
Motor 2 0~200% 90 ○ ○
11-07
Detection Time for
Phase-loss 0.01~600.00 sec 0.20 ○ ○ ○ ○ ○
11-08 Reserved
11-09 Level of Phase-loss 0.0~320.0 60.0 ○ ○ ○ ○ ○
11-10
Speed Feed Forward
Gain 0~100% 0 ○
11-11 Zero-speed Bandwidth 0~40Hz 10 ○ ○ ○
11-12
Speed Response of
Flux Weakening Area 0: Disable
0~150% 65 ○
11-13 Notch Filter Depth
0~20db 0 ○
11-14 Notch Filter Frequency 0.00~200.00 0.00 ○
11-15
Gain Value of Slip
Compensation
0.00~1.00 1.00 ○
11-16
Low-pass Filter Time
of Keypad Display
0.001~65.535sec 0.100 ○ ○ ○ ○ ○
11-17
Low-pass Filter Time
of PG2 Pulse Input
0.000~65.535sec 0.100 ○ ○ ○ ○
11-18 APR Gain 0.00~40.00 10.00 ○
11-19 APR Curve Time 0.00~655.35 sec 3.00 ○
11-20
|
11-28
Reserved
11-29
Accumulative
Operation Time of
Phase-loss
0~65535 (hour) 0 ○ ○ ○ ○ ○
11-30
|
11-40
Reserved