Reviewing data at the monitor, Reviewing snapshots – Welch Allyn 901061 Propaq LT Vital Signs Monitor - User Manual User Manual

Page 96

Storing and reviewing patient data

Welch Allyn Propaq LT Vital Signs Monitor

Reviewing data at the monitor

Snapshots and trend data can be reviewed at the monitor.

Reviewing snapshots

To review snapshots

From any main display screen (such as Large numerics, Dual waveform...):

Highlight

, HR/PR, SpO2, NIBP, Resp, or

Press

Highlight Snapshots and press

. The Snapshots display appears.

Figure 92. Snapshots display

The monitor first displays Select. With Select highlighted, press

to view the list of

up to 20 snapshots. To view another snapshot, highlight the snapshot menu (#5 of 5
in the example above), press

, and highlight any of the available snapshots.

The blue markers at the bottom of the waveform display represent one-second
intervals. The numeric data above the waveform represents the patient’s vital signs
measured at a specific time relative to that indicated in the lower right corner. For
example: In

Figure 92

, the data was measured at “1 Sec after” 14:34:58.

To view the waveform and the numeric data for a specific time within the 21 seconds
of data, highlight 1 Sec after and then use

scroll the display to the desired time.

For example, to see the vital signs taken five seconds after the trigger point of the
snapshot, highlight 1 Sec after and press and hold

as needed to increment the

display to 5 Sec after.

Figure 93. Snapshots display: 5 seconds after the button press

STEWART, ANN

7762940

15:14:28

Adult

Rm 263

HR/min

NIBP mmHg

Resp/min

SpO2

II 1mV/cm

Snapshots

2/21/05

1 Sec after

14:34:58

n/a

#5 of 5