Welch Allyn 901061 Propaq LT Vital Signs Monitor - User Manual - Manual (Page 52)

48 Standalone monitoring Welch Allyn Propaq LT Vital Signs Monitor
Figure 45. Start-up with saved data
• If the data from the previously monitored patient was deleted on shut-down, the
“no data saved” start-up screen appears:
Figure 46. Start-up with no saved data
3. Highlight Start New Patient and press . The first configured data display appears.
In place of a patient name, ID: is followed by a string that is generated by the monitor
when you select ‘Start New Patient’. This AutoID string, unique to each new patient,
identifies the patient until you supply appropriate patient identification data.
Figure 47. Data display with AutoID
4. In the primary data display, highlight ID: (upper left) and press .
The Patient Information Entry screen appears:
Note To bypass patient ID entry, press .
Select ( ) to delete data Select ( ) to delete data
and start a new patient. and start a new patient.
Portland Westside Hospital Portland Westside Hospital
Emergency Department Emergency Department
Note! Note!
There is patient data stored for There is patient data stored for
Hall, Robert E. ID: 3456187 Hall, Robert E. ID: 3456187
Start New Patient Start New Patient Continue Patient Continue Patient Info Info Demo Demo
Select ( ) to Start a New Patient. Select ( ) to Start a New Patient.
No data saved. No data saved.
Start New Patient Start New Patient Info Info Demo Demo
Portland Westside Hospital Portland Westside Hospital
Emergency Department Emergency Department
ID: 0101819RO17Q ID: 0101819RO17Q 8:82:56 8:82:56
Adult Adult Rm Rm
NIBP mmHg NIBP mmHg Resp/min Resp/min
HR/min HR/min SpO2 SpO2
%
S D M
Start - up AutoID