Selecting a language, About the charging/communications cradle – Welch Allyn 901061 Propaq LT Vital Signs Monitor - User Manual User Manual
Page 18

14
Overview of monitor operation
Welch Allyn Propaq LT Vital Signs Monitor
Selecting a language
To change the language of the monitor interface
1.
If the monitor power is on, press
to turn it off.
2.
Press
to turn the monitor power on.
3.
Immediately after pressing
, and before any screen appears, simultaneously press
and
. Keep the buttons pressed until the language selection screen appears.
Figure 8. Language selection screen
4.
Press
,
, , and
to highlight the language you wish to use.
5.
Press
.
Power-on continues in the selected language.
The monitor always powers on in this language until the setting is changed again. The
setting can be changed again only if one of the following occurs:
•
This procedure is repeated.
•
A new configuration is downloaded from a PC. (See
Utility to configure the monitor”
•
A new configuration is downloaded from Acuity.
About the charging/communications cradle
When the charging/communication cradle (the cradle) is attached to AC power (or to
vehicle DC power) and the monitor is seated in the cradle, the cradle does the following:
•
Recharges the monitor battery, whether patient monitoring is occurring or not.
•
Powers the monitor, conserving the charge on the monitor battery.
•
(If the cradle has the USB data transfer option) enables data transfer between a
PC and a monitor. See
“About the USB data transfer option”
Note
If you select French, HR/PR alarm limits cannot be turned off unless you go
through the service menus to change this setting. If you do change this setting,
the change stays in effect through power cycles.
For information about using the service menus, refer to the Propaq LT Monitor
Service Manual (810-1811-XX).
English
English
Deutsch
Deutsch
Français
Français
Español
Español
Italiano
Italiano
Polski
Polski
Nederl
Nederl
Svenska
Svenska
Português
Português
Japanese
Japanese