Welch Allyn 901061 Propaq LT Vital Signs Monitor - User Manual - Manual (Page 123)

Directions for Use PC utility 119
Configuration Utility command options
Error messages
These messages are displayed at the PC if communication or version problems arise
between the Configuration Utility and the monitor.
File
New The utility opens a new configuration file with all settings at the
factory values. Change the settings as needed and save the file
under a new name.
Open Open a configuration file. You can modify it (Save), use it as the
starting point for a new file (Save As), or close it (Exit).
Save Save the changes to the open configuration file.
Save As Save the open configuration file under a new name.
Print Preview Access options for previewing and printing report pages.
Print Print a report of configuration settings.
Exit Close the configuration file.
Edit
Cancel Edits Cancel all changes made since the last ‘Save’.
Monitor
Receive Upload the configuration file from the monitor to the PC.
Note: The configuration file on the monitor does not necessarily
reflect the current monitor configuration.
Note: If the monitor is older than version 1.30.00, the
Configuration Utility cannot receive the file.
Note: If the monitor configuration file was created using a
Configuration Utility older than version 1.30.00, some parameters
are not defined. The ‘Receive’ function sets these parameters to
the factory defaults.
Send Configure the monitor by downloading the displayed configuration
file.
Help
Version
Compatibility Display information about downloading configuration files when
the monitor and the Configuration Utility versions do not match.
About Display the version of the Configuration Utility.
Message
Communication with the monitor failed. Verify that the monitor is powered on and
properly seated in the cradle. Verify that the cable is connected.
Could not read patient data from the monitor. Please contact Welch Allyn customer
service.