Welch Allyn 901061 Propaq LT Vital Signs Monitor - User Manual - Manual (Page 94)

90 Alarms and alerts Welch Allyn Propaq LT Vital Signs Monitor
NIBP calibrating. The monitor will resume operation when the calibration is complete.
Button pad locked. Buttons (including the on/off button) remain locked until you unlock them or
until an alarm or an alert sounds.
Check SpO2 sensor. The sensor cable is faulty, incorrectly inserted, or incompatible. This message
persists until a valid cable is connected or until monitor power is cycled.
Retry in progress. An NIBP automatic retry is in progress.
Low perfusion index. Masimo only.
SpO2 interference. Masimo only.
SpO2 sensor off. Masimo only.
SpO2 ambient light. Masimo only.
Low Signal IQ. Masimo only.
Table 8. Status messages
Message Notes