Welch Allyn 901061 Propaq LT Vital Signs Monitor - User Manual - Manual (Page 45)

Directions for Use Overview of monitor operation 41
Figure 35. Demo mode: initial display
When you enter Demo mode, the monitor is in ‘Demo mode low’. In this mode, the
simulated vital signs of the patient are steady and do not cause any alarms at the default
alarm limit settings. You can explore the monitor displays and menus, and you can change
the same settings and values in Demo mode that you can change in normal mode.
In Demo mode low, if you adjust the alarm limits to put the simulated patient’s vital signs
out of limits, the monitor simulates an alarm condition. Another way to simulate an alarm
condition is to switch the monitor to Demo mode high, which uses higher numeric values.
To switch to demo mode high
1. Access the Setup menu. ( “To access the setup menus” on page 37.)
2. Press to highlight Timings.
Figure 36. Setup: timings
80 80 97 97
12 12
ID: 01018VDO9PBH ID: 01018VDO9PBH 3:00:06P 3:00:06P
Adult Adult Rm 239 Rm 239
NIBP mmHg NIBP mmHg Resp/min Resp/min
HR/min HR/min SpO2 SpO2
%
SIMULATION SIMULATION
S D M
II 1mV/cm II 1mV/cm
Exit Exit Trends Trends Snapshots Snapshots Setup Setup
Low Low Med Med
80 80
HR/min HR/min NIBP mmHg NIBP mmHg Resp/min Resp/min SpO2 SpO2
Off Off On On
Alarm Tone Alarm Tone
Suspend Audible Alarms Suspend Audible Alarms
Setup Setup
(90 sec) (90 sec)
12 12 97 97 % %
ID: 01018VDO9PBH ID: 01018VDO9PBH 3:00:06P 3:00:06P
Adult Adult Rm 239 Rm 239
Alarms Alarms ECG ECG NIBP NIBP Timings Timings
High High
Service Service
Configuration Configuration
Timings
Default demo mode (Low)