Welch Allyn 901061 Propaq LT Vital Signs Monitor - User Manual - Manual (Page 75)

Directions for Use Standalone monitoring 71
To discontinue monitoring
1. Press . The Power Off screen appears.
Figure 76. Power-off
• If you intend to continue monitoring the same patient when the monitor is turned
on again, and if you want to save the stored vital-signs data and monitor settings
(to print them at a PC), highlight Save & Shut Down and then press
. The
monitor saves the patient data and the monitor settings, and then turns off.
• If you do not intend to continue monitoring the same patient when the monitor is
turned on again, highlight Delete & Shut Down and then press
. The monitor
turns off without saving the data and the settings.
2. Disconnect the leads and sensors from the patient.
If you press and then decide that instead of turning off the monitor you want to resume
monitoring the same patient, do one of the following:
• Highlight Cancel and press .
• Wait for 30 seconds.
• Press .
ID: 12549M6I9ERF ID: 12549M6I9ERF 03:53:45 03:53:45
Adult Adult Rm Rm
NIBP mmHg NIBP mmHg
HR/min HR/min SpO2 SpO2
% %
S S D D M M
Note! You are changing the Note! You are changing the
default settings to factory
default settings to factory
If this is correct, highlight If this is correct, highlight
“Confirm” and then press
“Confirm” and then press
Cancel Cancel Confirm Confirm
settings. settings.
Select ( ). Select ( ).
Note When you power down from Demo mode, you cannot save settings and
patient data.
Select ( ) to delete patient data Select ( ) to delete patient data
You have pressed the Power Off button. You have pressed the Power Off button.
Delete & Shut Down Delete & Shut Down Cancel Cancel Setup Setup
and shut down. and shut down.
15:01:24 15:01:24
Adult Adult Rm 239 Rm 239
There is patient data stored for There is patient data stored for
Hall, Robert E. ID: 3456187 Hall, Robert E. ID: 3456187
Save & Shut Down Save & Shut Down
HALL, ROBERT E. HALL, ROBERT E. 3456187 3456187