beautypg.com

Establishing communication with acuity, Hall, robert e – Welch Allyn 901061 Propaq LT Vital Signs Monitor - User Manual User Manual

Page 78

background image

74

Monitoring in communication with Acuity

Welch Allyn Propaq LT Vital Signs Monitor

Establishing communication with Acuity

If the monitor is enabled for communication with Acuity, communication is established
automatically whenever the monitor is within range of the network.The monitor always
indicates the status of the connection:

Figure 77. Connection status indicator

Verify that the monitor, within a minute or two, displays

to indicate that the connection

to Acuity has been established.

Upon connecting to the network, the monitor uploads the following data to Acuity:

Patient information and trends stored at the monitor before the network
connection was established

Monitor settings

At the same time, Acuity downloads some configuration settings to the monitor. (See

“About Acuity-defined configuration”

on page 104.)

For information on monitoring vital signs, see the following:

Note

When the monitor is used in Canada:

To provide maximum shielding (to prevent radio interference to the licensed
service), the monitor is intended to be operated indoors and away from windows.
Radio equipment (or its transmit antenna) that is installed outdoors is subject to
licensing.

Afin de fournir un écran de blindage maximal (pour empêcher que cet appareil
cause du brouillage au service faisant l’objet d’une licence), l’appareil doit être
utilisé à l’intérieur et devrait être placé loin des fenêtres. Si le matériel (ou son
antenne d’émission) est installé à l’extérieur, il doit faire l’objet d’une licence.

ECG/Resp

“Monitoring ECG and Resp”

on page 52

SpO

2

“Monitoring SpO

2

on page 60

NIBP

“Monitoring blood pressure (NIBP)”

on page 65

%

140/78

80

12

97

HALL, ROBERT E.

HALL, ROBERT E.

3456187

3456187

3:00:06P

3:00:06P

Adult

Adult

Rm 239

Rm 239

HR/min

NIBP mmHg (102)
@2:47P Manual

Resp/min

SpO2

II 1mV/cm

The monitor is associated with the network and is
communicating with Acuity.

(Flashing) The monitor is associated with the network but
is not communicating with Acuity.

(Continuous) The monitor is not associated with the
network and is not communicating with Acuity.

The monitor is not enabled for communication with Acuity.

(blank)

The monitor is communicating via USB cable with a PC.