Welch Allyn 901061 Propaq LT Vital Signs Monitor - User Manual - Manual (Page 74)

70 Standalone monitoring Welch Allyn Propaq LT Vital Signs Monitor
• Download another configuration from a PC. (See “Using the Configuration Utility
to configure the monitor” on page 116.)
To save the current settings as the new default settings
1. Access the Configuration Setup menu.
2. Highlight Select ( ) to save current settings and press .
3. In the confirmation screen, highlight Confirm and press .
To restore the last downloaded configuration
1. Access the Configuration Setup menu, highlight Select ( ) to use file:
configuration_file_name, and press .
2. In the confirmation screen, highlight Confirm and press .
To restore the factory configuration
1. Access the Configuration Setup menu, highlight Select ( ) to use factory settings,
and press .
2. In the confirmation screen, highlight Confirm and press .
II 1mV/cm
Exit Exit Trends Trends Snapshots Snapshots Setup Setup
80 80
HR/min HR/min NIBP mmHg NIBP mmHg Resp/min Resp/min SpO2 SpO2
Select ( ) to save current settings. Select ( ) to save current settings.
12 12 97 97 % %
ID: 01018VDO9PBH 3:00:06P
Adult Rm 239
Select ( ) to use factory settings. Select ( ) to use factory settings.
Select ( ) to use file: n/a Select ( ) to use file: n/a
Setup Setup Alarms Alarms ECG ECG NIBP NIBP Timings Timings
Service Service
Configuration Configuration
ID: 12549M6I9ERF ID: 12549M6I9ERF 03:52:57 03:52:57
Adult Adult Rm Rm
NIBP mmHg NIBP mmHg
HR/min HR/min SpO2 SpO2
% %
S S D D M M
Note! You are changing the Note! You are changing the
default settings to current
default settings to current
If this is correct, highlight If this is correct, highlight
“Confirm” and then press
“Confirm” and then press
Cancel Cancel Confirm Confirm
settings. settings.
Select ( ). Select ( ).
ID: 12549M6I9ERF ID: 12549M6I9ERF 03:53:45 03:53:45
Adult Adult Rm Rm
NIBP mmHg NIBP mmHg
HR/min HR/min SpO2 SpO2
% %
S S D D M M
If this is correct, highlight If this is correct, highlight
“Confirm” and then press
“Confirm” and then press
Cancel Cancel Confirm Confirm
Select ( ). Select ( ).
Note! You are changing the Note! You are changing the
default settings to file:
default settings to file:
post-op4 15 Dec 06 post-op4 15 Dec 06