Welch Allyn 901061 Propaq LT Vital Signs Monitor - User Manual - Manual (Page 121)

Directions for Use PC utility 117
Modifying a configuration file
To modify a configuration file
1. Open the file.
2. Modify the settings.
3. Save the file.
Configuring a monitor
See “System requirements” on page 114.
To configure a monitor
1. Connect the PC to a cradle, using the supplied USB cable.
2. Seat the monitor in the cradle.
3. If the monitor is off, turn it on and select Start New Patient.
4. Start the utility.
5. Select the configuration file that you want to upload.
6. Click Monitor > Send.
7. Wait a few seconds. When the upload is complete, a completion message appears
and then the monitor shuts off.
8. Remove the monitor from the cradle. It is now configured.
Note To receive the configuration file from the monitor, click Monitor > Receive.