Continuing to monitor a patient on power-up – Welch Allyn 901061 Propaq LT Vital Signs Monitor - User Manual User Manual
Page 55

Directions for Use
Standalone monitoring
51
Figure 53. Time/date screen: 12-hour format
c.
When the time and date are correct and formatted appropriately, press
to
accept the changes and return to the vital-signs display.
Continuing to monitor a patient on power-up
If patient data was saved when the monitor was last turned off (see
on page 44), you can resume monitoring that patient when the monitor is turned
on again. (When patient data is saved, the monitor settings are also saved.)
To resume monitoring the same patient:
1.
Turn on the monitor. The “patient data stored” screen appears:
Figure 54. Start-up with saved data
2.
Verify that the displayed name and ID match that of the current patient.
3.
Highlight Continue Patient and press
.
Note
If you change the time or date settings and then decide not to accept the
changes, press
to cancel the changes and return to the vital-signs display.
II 1mV/cm
II 1mV/cm
Year
Year
Date Format
Date Format
HR/min
HR/min
NIBP mmHg
NIBP mmHg
Resp/min
Resp/min
SpO2
SpO2
%
14:49:54
14:49:54
Adult
Adult
Time Format
Time Format
Hour
Hour
Minute
Minute
Month
Month
Day
Day
HALL, ROBERT E.
HALL, ROBERT E.
3456187
3456187
Rm 239
Rm 239
12 Hour
12 Hour
24 Hour
24 Hour
2P
2P
45
45
3
17
17
2005
2005
mm/dd/yy
mm/dd/yy
dd.mm.yy
dd.mm.yy
yy/mm/dd
yy/mm/dd
Set
Set
Cancel
Cancel
12-hour format
Select ( ) to delete data
Select ( ) to delete data
and start a new patient.
and start a new patient.
Portland Westside Hospital
Portland Westside Hospital
Emergency Department
Emergency Department
Note!
Note!
There is patient data stored for
There is patient data stored for
Hall, Robert E. ID: 3456187
Hall, Robert E. ID: 3456187
Start New Patient
Start New Patient
Continue Patient
Continue Patient
Info
Info Demo
Demo