HP NetRAID-4M Controller - Manual (Page 99)

5-21
Working with Disksets
To change a diskset’s label, use the disk_set changelabel
command, as in the following example. In the example, the
command changes the label of the diskset whose diskset ID is
0x01be868c1d74a640
and whose creator ID is 0xfafaf001007a1c00 to
Mercury .
HPN0>disk_set changelabel 0x01be868c1d74a640 0xfafaf001007a1c00
Mercury
Executing: disk_set changelabel 125,685,775,960,680,000
-361,712,932,956,267,520 "Mercury"
After running the disk_set changelabel command to change
the label of a diskset, use the disk_set list command to display
information about your disksets, as in the following example. In the
example, the Label column indicates that Mercury is the diskset’s
label. Note that the example alters the
disk_set list output so
that the data can fit on the page.
HPN0> disk_set list
Executing: disk_set list
Diskset ID Creator ID Owner
------------------- ------------------ ------------------
0x01be868c1d74a640 0xfafaf001007a1c00 \\.\HPN0
Disks Attached OS Managed Label Shared Spare
------ -------- ---------- ---------- ------ -----
3 NO NO Mercury YES NO
Changing Ownership of a Diskset
You initially specify the ownership of a diskset when you create a
diskset using the
disk_set create command. See Creating a
Diskset on page 5-11 for information on creating a diskset. The CLI
allows you to change the ownership of a diskset as follows:
■ Take ownership of a diskset
■ Force ownership of a diskset
■ Release ownership of a diskset