HP NetRAID-4M Controller - Manual (Page 298)

13-10
Command Line Interface User’s Guide
Before resuming a task, use the task list command to display
information about all tasks running on a controller, as in the
following example. In the example, the State column indicates SUS,
which means that task 107 has been suspended.
HPN0> task list
Executing: task list
Controller Tasks
TaskId Function Done% Container State Specific1 Specific2
------ -------- ------- --------- ----- --------- ---------
107 Scrub 60% 00 SUS 00000000 00000000
To resume task 107, use the task resume command, as in the
following example. In the example, the task resume command
resumes the task with the task ID of 107.
HPN0> task resume 107
Executing: task resume 107
After executing the task resume command, use the task list
command to verify that task 107 has been resumed, as in the
following example. In the example, the State column indicates
RUN
, which means that task 107 has been resumed.
HPN0> task list
Executing: task list
Controller Tasks
TaskId Function Done% Container State Specific1 Specific2
------ -------- ------- --------- ----- --------- ---------
107 Scrub 67% 00 RUN 00000000 00000000
❒