HP NetRAID-4M Controller - Manual (Page 90)

5-12
Command Line Interface User’s Guide
After running the disk_set create command to create a diskset,
use the disk_set list command to display information about
your disksets, as in the following example. In the example, the
Diskset ID
column indicates that the diskset ID is
0x01be868c1d74a640 , the Creator ID column indicates that the
creator ID is 0xfafaf001007a1c00, the Owner column indicates that
the Owner is \\.\HPN0, and the Label column indicates that
Saturn
is the diskset label. Note that the example alters the
disk_set list output so that the data can fit on the page.
HPN0> disk_set list
Executing: disk_set list
Diskset ID Creator ID Owner
------------------- ------------------ ------------------
0x01be868c1d74a640 0xfafaf001007a1c00 \\.\HPN0
Disks Attached OS Managed Label Shared Spare
------ -------- ---------- ---------- ------ -----
2 NO NO Saturn YES NO
Adding a Disk to a Diskset
You use the disk_set add command to add one or more disks to a
diskset. To use this command, the diskset must have been
previously created. See Creating a Diskset on page 5-11 for
information on creating a diskset.
Before adding a disk to a diskset, use the disk_set list
command to display information about your disksets, as in the
following example. In the example, the Disks column indicates that
there are 2 disks in the diskset. Note that the example alters the
disk_set list output so that the data can fit on the page.
HPN0> disk_set list
Executing: disk_set list
Diskset ID Creator ID Owner
------------------- ------------------ ------------------
0x01be868c1d74a640 0xfafaf001007a1c00 \\.\HPN0
Disks Attached OS Managed Label Shared Spare