HP NetRAID-4M Controller - Manual (Page 75)

4-25
Working with Disks
Displaying and Enabling Error Logging
The log errors attribute indicates whether S.M.A.R.T. exception
logging is enabled.
The CLI allows you to do the following:
■ Display whether S.M.A.R.T. error logging is enabled
■ Enable S.M.A.R.T. error logging
To determine whether S.M.A.R.T. error logging is enabled, use the
disk show smart command, as in the following example. Note
that the Log Errors column appears only if you specify the /full
switch with the disk show smart command. In the following
example, the Log Errors column indicates whether S.M.A.R.T. error
logging is enabled for a device. In the following example, the N in
the Log Errors column indicates that error logging is not enabled for
devices (2,1,0) and (2,2,0). (Note that the example eliminates some
items in the
disk show smart display to make the example
readable on this page.)
HPN0> disk show smart /full=TRUE
Executing: disk show smart /full=TRUE
Smart
Capable Log Interval Report Error
C:ID:L Device Errors Timer (secs.) Count Count
------ ------- ------ ------------- ------ -----
2:01:0 Y N 0 1 0
2:02:0 Y N 0 1 0
To enable error logging, use the disk set smart command with
the /logerr switch. The following example shows how to enable
S.M.A.R.T. error logging on SCSI device (2,1,0):
HPN0> disk set smart /logerr=TRUE (2,1,0)
Executing: disk set smart /logerr=TRUE (CHANNEL=2,ID=1,LUN=0)
SMART parameters on disk (2,01,0) were successfully set.
You can disable error logging setting the /logerr switch to FALSE .
After enabling S.M.A.R.T. error logging, use the disk show smart
command to verify the log errors setting. See Displaying and Enabling
Error Logging on page 4-25 for further information.