HP NetRAID-4M Controller - Manual (Page 266)

10-10
Command Line Interface User’s Guide
information about your containers, as in the following example. In
the example, the State column indicates Snapped for container
0+62
, which means that container 0 is the original container on
which the snapshot was taken. The State column also indicates
SnpShot
for container 1+63, which means that container 1 is the
snapshot (backing) container.
HPN0> container list /full=TRUE
Executing: container list /full=TRUE
Cluster Num Total Oth Stripe Scsi
Dr Partner Label Type Size Ctr Size Usage C:ID:L State RO
-- ------- ----- ------ ------ --- ------ ------- ------ ------- --
0 0+62 Volume 100MB 1 None 2:01:0 Snapped
0 1+63 Stripe 200MB 0 32KB None 2:02:0 SnpShot
2:03:0 SnpShot
To remove the link between the original container and a snapshot
container, use the
container remove snapshot command, as in
the following example. In the example, the container remove
snapshot command removes the link to the snapshot container
whose container ID is 1.
HPN0> container remove snapshot 1
Executing: container remove snapshot 1
After running the container remove snapshot command, use
the container list command with the /full switch to display
information about the snapshot container, as in the following
example. In the example, the Num Label column indicates 0 and 1,
which are the container IDs that existed before the snapshot
container was created. The State column indicates blank spaces and
no longer shows the Snapped and SnpShot values, which means
that the snapshot was removed. (Note that the example eliminates
some items in the
container list display to make the example
readable on this page.)
HPN0> container list /full
Executing: container list /full=TRUE
Cluster Num Total Oth Stripe Scsi
Dr Partner Label Type Size Ctr Size Usage C:ID:L State RO
-- ------- ----- ------ ------ --- ------ ------- ------ ------- --
0 0 Volume 100MB 1 None 2:01:0
0 1 Stripe 200MB 0 32KB None 2:02:0