HP NetRAID-4M Controller - Manual (Page 73)

4-23
Working with Disks
After setting the MRIE value, use the disk show smart command
to verify the MRIE setting.
Displaying and Enabling the Exception Control Setting
The enable exception control attribute indicates whether
exception reporting is enabled. Exception reporting is a S.M.A.R.T.
feature that reports exceptions according to the Method of Reporting
Informational Exceptions (MRIE) method, which is described in
Displaying and Enabling the MRIE Performance Setting on page 4-24.
The CLI allows you to do the following:
■ Display whether Exception Control (reporting) is enabled
■ Enable exception control
To display whether exception control is enabled for the disks on a
controller, use the
disk show smart command, as in the
following example. In the example, the Enable Exception Control
column displays a N, indicating that exception reporting is enabled
for devices (2,1,0) and (2,1,0).
HPN0> disk show smart
Executing: disk show smart
Smart Method of Enable
Capable Informational Exception Performance Error
C:ID:L Device Exceptions(MRIE) Control Enabled Count
------ ------- ---------------- --------- ----------- ------
2:01:0 Y 6 N N 0
2:02:0 Y 6 N N 0
To enable S.M.A.R.T. exception reporting, use the disk set smart
command with the /enable_exceptions switch. The following
example shows how to enable exception reporting on SCSI device
(2,1,0):
HPN0> disk set smart /enable_exceptions=TRUE (2,1,0)
Executing: disk set smart /enable_exceptions=TRUE
(CHANNEL=2,ID=1,LUN=0)
SMART parameters on disk (2,01,0) were successfully set.
After enabling exception reporting, use the disk show smart
command to verify the Enable Exception Control setting. See