HP NetRAID-4M Controller - Manual (Page 287)

12-9
Working with Event Notification
To send a test e-mail notification message, use the mail test
command, as in the following example. In the example, the mail test
command sends an e-mail notification message using the local
computer and domain to [email protected]. Note that the
Subject
item and the message This is a test mail message are
supplied by the system.
HPN0> mail test "[email protected]"
Executing: mail test "[email protected]"
The content of the test e-mail notification message is as follows:
From: [email protected] Sent:Wed 8/6/97 1:55 PM
To: [email protected]
Cc:
Subject: A test message.
This is a test mail message.
Clearing Mail Message Reporting
The CLI allows you to clear (disable) controller event e-mail
message reporting for one or more events. To clear e-mail message
reporting, use the
mail clear message command. You
previously set (enabled) e-mail message reporting for one or more
events using the
mail set message command.
How to Clear the Mail Server
This section provides an example that describes how to clear e-mail
message notifications from the e-mail server.
To display e-mail message information for all controller event types,
use the
mail show message command, as in the following
example. In the example, the output of the mail show message
command with the /all switch indicates that e-mail message
reporting is set only for the DriveLetterChange event.
HPN0> mail show message /all=TRUE
Executing: mail show message /all=TRUE
Message : DriverLetterChange
To : [email protected]
Subject : HP NetRAID-4M controller message