HP NetRAID-4M Controller - Manual (Page 57)

4-7
Working with Disks
controller. To determine the usage of your disks, use the disk list
command. Table 4-2 shows the possible disk usage values:
Table 4-2. Disk Usage Values.
In the following example, the Usage column indicates that device
2:01:0 is initialized for use with containers.
HPN0> disk list
Executing: disk list
C:ID:L Device Type Blocks Bytes/Block Usage Shared
------ ----------- --------- ----------- ---------------- ------
2:01:0 Disk 17783240 512 Initialized NO
2:02:0 Disk 17783240 512 Initialized NO
Displaying Disk Defects
The disk defect attribute indicates the following:
■ The total number and location of primary defects on a disk.
Primary defects are disk defects that originate during the
manufacturing of a disk.
To display the location and number of primary defects on a
disk connected to your RAID controller, use the
disk show
defects command. The following example shows the output
Value Meaning
DOS The SCSI device was prepared for use
with DOS partitions.
Initialized The SCSI device was prepared (initialized)
for use with containers. This is the value
that appears in the example.
Not initialized The SCSI device was not prepared
(initialized) for use with containers
Offline The SCSI device was present at boot time;
however, the device is either removed
from the controller or it failed.
Unknown The SCSI device is not owned by the
controller.