HP NetRAID-4M Controller - Manual (Page 96)

5-18
Command Line Interface User’s Guide
Attaching a Diskset
Attaching a diskset makes the diskset available for use by the
controller and the host operating system. You use the
disk_set
attach command to attach a diskset to a controller. To attach a
diskset, the diskset must be owned by either the controlling or peer
partner.
Before attaching a diskset, use the disk_set list command to
display information about your disksets, as in the following
example. In the example, the Attached column indicates NO, which
means that the diskset is not attached. Note that the example alters
the
disk_set list output so that the data can fit on the page.
HPN0> disk_set list
Executing: disk_set list
Diskset ID Creator ID Owner
------------------- ------------------ ------------------
0x01be868c1d74a640 0xfafaf001007a1c00 \\.\HPN0
Disks Attached OS Managed Label Shared Spare
------ -------- ---------- ---------- ------ -----
3 NO NO Saturn YES NO
To attach a diskset, use the disk_set attach command, as in the
following example. In the example, the command attaches the
diskset whose diskset ID is 0x01be868c1d74a640 and whose creator
ID is 0xfafaf001007a1c00.
HPN0> disk_set attach 0x01be868c1d74a640 0xfafaf001007a1c00
Executing: disk_set attach 681,522,135,130,238,977
-361,712,932,956,267,520
After running the disk_set attach command to attach a diskset,
use the disk_set list command to display information about
your disksets, as in the following example. In the example, the
Attached
column indicates YES, which means that the diskset is
attached. Note that the example alters the disk_set list output
so that the data can fit on the page.
HPN0> disk_set list
Executing: disk_set list
Diskset ID Creator ID Owner