HP NetRAID-4M Controller - Manual (Page 92)

5-14
Command Line Interface User’s Guide
(2:00:0) , (2:01:0), and (2:02:0). Note that the example alters the
disk_set list output so that the data can fit on the page.
HPN0> disk_set list /members
Executing: disk_set list
Diskset ID Creator ID Owner
------------------- ------------------ ------------------
0x01be868c1d74a640 0xfafaf001007a1c00 \\.\HPN0
Disks Attached OS Managed Label Shared Spare
------ -------- ---------- ---------- ------ -----
3 NO NO Saturn YES NO
Members of the Disk Set:
C:ID:L
-------
2:00:0
2:01:0
2:02:0
To remove a disk from a diskset, use the disk_set remove
command, as in the following example. In the example, SCSI device
(2,2,0)
is removed from the diskset whose diskset ID is
0x01be868c1d74a640 and whose creator ID is 0xfafaf001007a1c00.
HPN0> disk_set remove 0x01be868c1d74a640 0xfafaf001007a1c00
(2,2,0)
Executing: disk_set remove 681,522,135,130,238,977
-361,712,932,956,267,520 (CHANNEL=2,ID=2,LUN=0)
After running the disk_set remove command to remove a disk
from a diskset, use the disk_set list command with the
/members switch to display information about your disksets, as in
the following example. In the example, the Disk column indicates 2,
which means that the diskset now has two disks. The C:ID:L column
indicates that the diskset consists of SCSI devices (2:00:0) and
(2:01:0)
. Note that the example alters the disk_set list output so
that the data can fit on the page.
HPN0> disk_set list /members
Executing: disk_set list
Diskset ID Creator ID Owner