HP NetRAID-4M Controller - Manual (Page 74)

4-24
Command Line Interface User’s Guide
Displaying and Enabling the Exception Control Setting on page 4-23 for
further information.
Displaying and Enabling the MRIE Performance Setting
The MRIE performance enabled attribute indicates whether to
report exceptions according to the MRIE method, taking disk
performance into consideration. If you enable this feature,
S.M.A.R.T. reports exceptions if disk performance has not degraded;
otherwise, exception reporting stops.
The CLI allows you to do the following:
■ Display whether MRIE performance is enabled
■ Enable MRIE performance
To display the MRIE performance setting, use the disk show
smart command, as in the following example. In the example, the
Performance Enabled column contains an N for both devices,
indicating that devices (2,1,0) and (2,2,0) are not enabled for MRIE
performance.
HPN0> disk show smart
Executing: disk show smart
Smart Method of Enable
Capable Informational Exception Performance Error
C:ID:L Device Exceptions(MRIE) Control Enabled Count
------ ------- ---------------- --------- ----------- ------
2:01:0 Y 6 Y N 0
2:02:0 Y 6 Y N 0
To enable S.M.A.R.T. MRIE performance, use the disk set smart
command with the /perf switch, as in the following example. The
example shows how to enable the MRIE performance feature on
SCSI device (2,1,0):
HPN0> disk set smart /perf=TRUE (2,1,0)
Executing: disk set smart /perf=TRUE (CHANNEL=2,ID=1,LUN=0)
SMART parameters on disk (2,01,0) were successfully set.
You can disable the performance feature setting the disk set
smart command’s /perf switch to FALSE . After enabling MRIE
performance, use the disk show smart command to verify the
MRIE performance setting.