HP NetRAID-4M Controller - Manual (Page 141)

6-35
Working with Container Attributes
To display whether a container is being used as a temporary
container in a
reconfiguration operation, use the container
list command with the /full switch, as in the following example.
In the example, the State column indicates Temp, which means that
container 61 (a hidden container) is being used as a temporary
container in a
container configuration operation. (Note that
the example eliminates some items in the container list display
to make the example readable on this page.)
HPN0> container list /full=TRUE
Executing: container list /full=TRUE
Cluster Num Total Oth Stripe Scsi Partition
Dr Partner Label Type Size Ctr Size Usage C:ID:L Offset:Size State
-- ------- ----- ------ ------ --- ------ ------- ------ ------------- ----
0 0 Reconf 100MB None
0 62 Stripe 100MB 32KB None 2:01:0 64.0KB: 100MB Dest
0 63 Volume 100MB None 2:01:0 64.0KB: 100MB Source
0 61 Stripe 1.00MB 32KB None 2:01:0 8.47GB:1.00MB Temp
Understanding Snapshot State Attributes
The snapshot state attributes indicate a container’s use during a
snapshot operation. Table 6-10 lists the snapshot state attributes,
the CLI operations associated with these attributes, the CLI
commands you use to perform these operations, and the section that
describes the operation.
Table 6-10. Snapshot State Attributes
Attributes
CLI
Operations Related
Commands
Discussed in...
snapshot
original
container create
complete
Display container
list
Displaying the
Snapshot Original
Container Create
Complete State
snapshot backing
container
Display container
list
Displaying the
Snapshot Backing
Container State