HP NetRAID-4M Controller - Manual (Page 176)

8-4
Command Line Interface User’s Guide
while creating a stripe set of mirror sets or at a later time using the
container set label command. See Displaying and Setting a
Container Label in Chapter 6, Working with Container Attributes, for a
description of the
container set label command.
In the following example, the container create mstripe
command with the /label switch creates a stripe set of mirror sets
with the label Pluto.
HPN0> container create mstripe /label=Pluto 0 1
Executing: container create mstripe /label="Pluto" 0 1
Container 0 created
Understanding How to Create a Stripe Set of Mirror Sets
This section provides an example that describes how to create a
stripe set of mirror sets.
Before creating a stripe set of mirror sets, be sure that the mirror sets
that are to be striped have been created. See Working with a Mirror Set
in Chapter 7, Working With Single-level Containers, for information on
creating a mirror set. Use the
container list command to
display information about your containers, as in the following
example. In the example, the Type column indicates two Mirror sets
that reside on containers 0 and 1.
HPN0> container list
Executing: container list
Cluster Num Total Oth Stripe Scsi Partition
Dr Partner Label Type Size Ctr Size Usage C:ID:L Offset:Size
-- ------- ----- ------ ------ --- ------ ------- ------ -------------
0 0 Mirror 100MB None 2:01:0 64.0KB: 100MB
2:02:0 64.0KB: 100MB
0 1 Mirror 100MB None 2:03:0 64.0KB: 100MB
2:04:0 64.0KB: 100MB
To create a stripe set of mirror sets, use the container create
mstripe command, as in the following example. In the example,
containers 0 and 1 are used to create a stripe set of mirror sets. The
stripe size is not specified; therefore, the stripe size is 32KB, which is
the default size.
HPN0> container create mstripe 0 1
Executing: container create mstripe 0 1
Container 0 created