HP NetRAID-4M Controller User Manual
Page 140

6-34
Command Line Interface User’s Guide
the example, the State column indicates Raid5, which means that
container 0 is being used as a RAID-5 set in a
container
configuration
operation. (Note that the example eliminates
some items in the
container list
display to make the example
readable on this page.)
HPN0> container list /full=TRUE
Executing: container list /full=TRUE
Cluster Num Total Oth Stripe Scsi
Dr Partner Label Type Size Ctr Size Usage C:ID:L State
-- ------- ----- ------ ------ --- ------ ------- ------ ------
0 0 Volume 100MB None 2:01:0 Raid5
Displaying the Reconfiguration Source Container State
The
reconfiguration source container state
attribute
indicates that a container is being used as the source container,
which is a hidden container used during a
container
reconfiguration
operation.
To display whether a container is being used as the source container
in a
reconfiguration
operation, use the
container list
command with the
/full
switch, as in the following example. In
the example, the State column indicates Source, which means that
container 63 (a hidden container) is being used as a source container
in a
container reconfiguration
operation. (Note that the
example eliminates some items in the
container list
display to
make the example readable on this page.)
HPN0> container list /full=TRUE
Executing: container list /full=TRUE
Cluster Num Total Oth Stripe Scsi Partition
Dr Partner Label Type Size Ctr Size Usage C:ID:L Offset:Size
State
-- ------- ----- ------ ------ --- ------ ------- ------ ------------- ----
0 0 Reconf 100MB None
0 62 Stripe 100MB 32KB None 2:01:0 64.0KB: 100MB Dest
0 63 Volume 100MB None 2:01:0 64.0KB: 100MB Source
0 61 Stripe 1.00MB 32KB None 2:01:0 8.47GB: 1.00MB Temp
Displaying the Reconfiguration Temporary Container State
The
reconfiguration temporary container state
attribute indicates that a container is being used as a temporary
container, which is a hidden container used during a
container
reconfiguration
operation.