HP NetRAID-4M Controller - Manual (Page 237)

9-29
Modifying Containers
0 2:03:0
Removing Spare Disks from a Single Container
The CLI allows you to remove one or more spare disks assigned to a
single container. To remove one or more spare disks assigned to a
single container, use the
container remove spare command.
To work with removing spare disks from a single container, you
must understand:
■ The remove spare disk attributes you can specify
■ How to remove spare disks from a single container
The following sections discuss each of these topics.
Understanding the Remove Spare Disk Attributes from a Single
Container You can Specify
You use the container remove spare command to remove
spare disks from a single container. The container remove
spare command has no attributes.
Understanding How to Remove Spare Disks from a Single Container
This section provides an example that describes how to remove a
spare disk from a single container.
Before removing one or more spare disks from a single container,
use the
container show spare command to display information
about your spare disks, as in the following example. In the example,
the Scsi C:ID:L column indicates that SCSI device 2:03:0 is assigned
as a spare disk for container 0.
HPN0> container show spare
Executing: container show spare
Container Scsi C:ID:L
_________ ___________________________
0 2:03:0
To remove one or more spare disks from a single container, use the
container remove spare command, as in the following
example. In the example, SCSI device (2,3,0) is removed as a spare
disk for container 0.
HPN0> container remove spare 0 (2,3,0)