HP Integrated Lights-Out 4 - Manual (Page 54)

•
Virtual Power and Reset
•
Virtual Media
•
Configure iLO Settings
•
Login Privilege
5. Click Add Group or Update Group to save the settings.
Removing an iLO system from an iLO Federation Management group
Use the following procedure to remove an iLO system from an iLO Federation Management group.
TIP: You can use RIBCL XML scripts to remove a batch of iLO systems from a group. For more
information, see the HP iLO 4 Scripting and Command Line Guide.
1. Navigate to the iLO Federation
→Group Configuration page, as shown in
Figure 23 (page
52) .
2. Select the check box next to the group membership that you want to delete.
3. Click Delete.
The following message appears:
Are you sure you want to delete the selected group(s)?
4. Click OK.
Configuring enclosure support for iLO Federation Management
If you want to use server blades in an enclosure with iLO Federation Management, you must
configure Enclosure iLO Federation Support on the Enclosure Settings
→Network Access→Protocols
page in the Onboard Administrator web interface. This step is required to allow peer-to-peer
communication between the server blades in an enclosure. Onboard Administrator 4.11 or later
is required to use this feature.
For more information, see the Onboard Administrator documentation.
To verify that a server blade is configured to be used with iLO Federation, navigate to the Device
Bays
→→iLO page, and verify that the iLO Federation Capable setting shows the
value Yes, as shown in Figure 24 (page 55) .
54 Configuring iLO