HP Integrated Lights-Out 4 - Manual (Page 189)

•
iLO—The fully qualified network name assigned to the iLO subsystem. Click the iLO link to
open the iLO web interface for the server.
•
IP—The network IP address of the iLO subsystem. Click the iLO link to open the iLO web
interface for the server.
Click Next or Previous to view more servers in the list.
Configuring iLO Federation Management group power settings
The group power settings feature enables you to set dynamic power caps for your grouped servers.
When using Automatic Group Power Capping, note the following:
•
When a group power cap is set, the grouped systems share power in order to stay below the
power cap. More power is allocated to busy servers and less power is allocated to servers
that are idle.
•
The power caps that you set for a group operate concurrently with the power caps that you
can set on the Power Settings page for an individual server.
•
When a power cap is set, the average power reading of the grouped servers must be at or
below the power cap value.
•
If you want to configure power capping settings for an iLO Federation Management group,
ensure that each member of the group has granted the Configure iLO Settings privilege to the
group. For more information about privileges, see
“Configuring iLO Federation Management”
(page 50) .
•
A license is required if you want to make changes on the Group Power Settings page. For
more information about iLO licensing, see the following website:
http://www.hp.com/go/
ilo/licensing .
•
You cannot use the iLO web interface to configure group power capping settings for SL servers.
Use one of the following tools to configure the power capping settings for SL servers:
◦ Power Interface Control Utility—This utility is available at the following website: http://
h20000.www2.hp.com/bizsupport/TechSupport/SoftwareDescription.jsp?
prodTypeId=15351&prodSeriesId=4324034&
swItem=MTX-cb0c48d305d24a4dbe80e5eecc&prodNameId=5037746
.
◦ HP ProLiant SL Advanced Power Manager—For more information, see the HP ProLiant SL
Advanced Power Manager User Guide.
The HP Automatic Group Power Capping Settings section enables you to view measured power
values, set a power cap, and disable power capping.
•
The Measured Power Values section lists the following:
Maximum Available Power—The total power supply capacity for all servers in a group
◦
◦ Peak Observed Power—The maximum observed power for the servers in a group
◦ Minimum Observed Power—The minimum observed power for the servers in a group
Using iLO Federation Management 189