HP Integrated Lights-Out 4 - Manual (Page 301)

Table 17 Event log entries (continued)
Description Event log entry
The system was booted with the Security Override Switch set to On. Security Override Switch
Setting is On
The system was booted with the Security Override Switch changed from On to
Off. Security Override Switch
Setting Changed to Off
The on-board clock was set. Displays the previous time or NOT SET if no time
was set. On-board clock set; was
previously [NOT SET]
The logs are full and the SNMP trap alert failed for a specified IP address. Logs full SNMP trap alert
failed for:
Security was disabled and the SNMP trap alert failed for a specified IP address. Security disabled SNMP trap
alert failed for:
address>
Security was enabled and the SNMP trap alert failed for a specified IP address. Security enabled SNMP trap
alert failed for:
address>
An authorized user connected the virtual floppy. Virtual Floppy connected by
An authorized user disconnected the virtual floppy. Virtual Floppy disconnected
by
An authorized user added a license. License added by:
An authorized user removed a license. License removed by:
A license activation error occurred. License activation error by:
An authorized user logged in to iLO RBSU. iLO RBSU user login:
A power request was received from one of the following: Power on request received
by: •
Power Button
•
Wake On LAN
• Automatic Power On
An authorized user clicked the Virtual NMI button. Virtual NMI selected by:
An authorized user started a Virtual Serial Port session. Virtual Serial Port session
started by:
An authorized user stopped a Virtual Serial Port session. Virtual Serial Port session
stopped by:
A login failure occurred. Virtual Serial Port session
login failure from:
Hardware and software link-related issues
iLO uses standard Ethernet cabling, which includes CAT 5 UTP with RJ-45 connectors.
Straight-through cabling is necessary for a hardware link to a standard Ethernet hub. Use a crossover
cable for a direct PC connection.
The default DNS name is displayed on the serial number/iLO information pull tab, and can be
used to locate iLO if you do not know the assigned IP address.
If you are using DHCP, the following information applies:
•
The iLO management port must be connected to a network that is connected to a DHCP server,
and iLO must be on the network before power is applied. DHCP sends a request soon after
Hardware and software link-related issues 301