Accessing the ilo 4 configuration utility menu, Using the uefi system utilities – HP Integrated Lights-Out 4 User Manual
Page 136
Figure 65 iLO RBSU Configure iLO Command-Line Interface window
6.
For each option that you want to change, select the option, and press the spacebar to toggle
through the available settings. You can change the following settings:
•
Serial CLI Status
•
Serial CLI Speed (bits/second)
For more information about these options, see
7.
Press F10 to save the settings.
8.
Select File
→Exit to close iLO RBSU.
Using the UEFI System Utilities iLO 4 Configuration Utility
HP ProLiant Gen8 servers that support UEFI include the HP UEFI System Utilities software, which is
embedded in the system ROM. To determine whether your server supports UEFI, see the server
documentation.
NOTE:
On servers that do not support UEFI, you can continue using the iLO RBSU. For more
information, see
“Using the iLO RBSU” (page 132)
.
For general instructions about using the UEFI System Utilities, see the HP UEFI System Utilities User
Guide.
This section provides general use instructions and instructions for configuring iLO with the iLO 4
Configuration Utility. For other iLO setup and troubleshooting procedures that you can perform
with the iLO 4 Configuration utility, see the following:
•
“Setting up iLO by using iLO RBSU or the iLO 4 Configuration Utility” (page 20)
•
“Troubleshooting miscellaneous issues” (page 318)
Accessing the iLO 4 Configuration Utility menu
You can access the iLO 4 Configuration Utility from the physical system console, or by using an
iLO remote console session.
136
Configuring iLO