HP Integrated Lights-Out 4 - Manual (Page 164)

◦ UDIMM
◦ LRDIMM
Viewing network information
The NIC Information page displays read-only information about the integrated and add-in NICs.
If the server is powered off, the system health information on this page is current as of the last
power off. Health information is updated only when the server is powered on and POST is complete.
The server IP address, add-in network adapters, and server NIC status are displayed only if the
Agentless Management Service is installed and running on the server.
To view NIC information, navigate to the Information
→System Information page, and then click
the Network tab, as shown in Figure 80 (page 164) .
Figure 80 System Information – NIC Information page
The following information is displayed:
•
Device Type—The device type is one of the following:
iLO 4—This device type is assigned to the iLO Dedicated Network Port or iLO Shared
Network Port. Users who have the Configure iLO Settings privilege can configure the iLO ◦
NIC settings on the General tab of the Network
→iLO Dedicated Network Port or
Network
→Shared Network Port page.
◦ NIC—This device type indicates NIC or LAN adapter components embedded in the server
or added after manufacturing. Because system NICs are directly available to the server
host operating system, the iLO firmware cannot directly obtain current IP addresses (or
other configuration settings) for these devices.
•
Network Port—The configured network port.
•
Location—The location of the NIC adapter on the system board.
•
MAC Address—The port MAC address.
•
IP Address—The host IP address.
•
Description—A description of the NIC.
•
Status—The NIC status.
164 Using iLO