HP Integrated Lights-Out 4 - Manual (Page 106)

11. Resume the normal boot process:
a. Start the iLO remote console.
The iLO 4 Configuration Utility is still open from the previous session.
b. Press ESC several times to navigate to the System Configuration page.
c. Press ESC to exit the System Utilities and resume the normal boot process.
Enabling the iLO Dedicated Network Port through the web interface
1. Connect the iLO Dedicated Network Port to a LAN from which the server is managed.
2. Log in to the iLO web interface.
3. Navigate to the Network
→iLO Dedicated Network Port page.
4. Click the General tab.
5. Select the Use iLO Dedicated Network Port check box.
6. Select a Link State.
For more information, see “Configuring general network settings” (page 91) .
7. Click Apply.
Your changes are applied to the iLO network configuration, your browser connection ends,
and iLO restarts. You must wait at least 30 seconds before you attempt to re-establish a
connection.
Configuring iLO Management settings
With iLO 3 and earlier, SNMP management used the HP Insight Management Agents running on
the server operating system. With iLO 4, you can use either Agentless Management or the Insight
Management Agents. The default configuration is to use Agentless Management.
iLO 4 Agentless Management uses out-of-band communication for increased security and stability.
With Agentless Management, health monitoring and alerting is built into the system and begins
working the moment a power cord is connected to the server. This feature runs on the iLO hardware,
independent of the operating system and processor. Additional operating system data is collected
when AMS is installed.
The Management – SNMP Settings page allows you to configure the iLO settings for SNMP, SNMP
alerts, and Insight Manager integration.
You must have the Configure iLO Settings privilege to change these settings.
Depending on your configuration, you might need to install additional software. For more
information, see
“Installing AMS or the Insight Management Agents” (page 107) .
Table 9 (page 107) provides a comparison of the information provided by the different HP ProLiant
Gen8 server configurations.
106 Configuring iLO