beautypg.com

Configure snmp settings – HP P6000 Performance Advisor Software User Manual

Page 67

background image

You can provide multiple email addresses by separating them with a semi colon. For
example, [email protected];[email protected];[email protected]

Source email address from where threshold and data collection alarm notifications should
be dispatched

(Optional) A descriptive subject for the email notification

(Optional) Select the Raise alarm when value drops below threshold level check box, if
you want to be notified when the threshold summary value drops below the selected notify
at threshold level.

Select the Raise alarm when value drops below threshold level check box, if you want to
be notified when the data collection starts or stops.

7.

Under Report Email Settings, select Send report email notifications check box.

8.

Enter the following specific details:

Destination email address where you want to receive the report email notifications (total
character count <= 512).

A valid destination email address must transform into one of the following formats:

@.

.

For example, [email protected]

@..

.

For example, [email protected]

You can provide multiple email addresses by entering them individually and clicking Add.

Source email address from where report email notifications should be dispatched

(Optional) A descriptive subject for the email notification

Max File Size can be configured between 1 to 5 MB (5 MB is by default). If the file size
exceeds the configured value, the report is emailed as a link.

9.

Click Save Changes.

Configure SNMP settings

Procedure

To configure SNMPv1 or SNMPv2 settings:
1.

In the SNMP Settings section, select the Enable Threshold SNMP Traps check box to enable
the fields.

2.

Specify the SNMP version by selecting SNMPv1 or SNMPv2 from the SNMP Version list.
SNMPv1 is the default selection.

3.

Enter the SNMP community name.

Any special character apart from ~ @ # $ % ^ & < > { * ( + ) _ : } is allowed.

4.

Enter the SNMP destination IP address and port number to which the traps are to be delivered,
and then click Add.

NOTE:

The Add button is enabled only when you start entering the SNMP IP address.

After you enter the SNMP destination IP addresses, the new SNMP server is added to the List
of SNMP Destination [Ports] list.

5.

Click Save Changes.

HP P6000 Performance Advisor starts dispatching SNMP traps to the specified SNMP destination
server.

Configuring monitoring settings in HP P6000 Performance Advisor

67

This manual is related to the following products: