Brocade Virtual ADX MIB Reference (Supporting ADX v03.1.00) - Manual (Page 95)

Brocade Virtual ADX MIB Reference 83
53-1003312-01
ACLs
snAgAclSourceOperator
brcdIp.1.2.2.15.2.1.8
Syntax: Operator Read-write Applies only to TCP or UDP ports in extended ACLs.
Indicates how the policy will be compared to the ports specified in the
“snAgAclSourceOperand1” and “snAgAclSourceOperand2” objects:
•
eq(0) – The policy applies only to packets whose source port
number matches the port number specified in the objects.
•
neq(1) – The policy applies only to packets whose source port
numbers are not included in the specified range.
•
lt(2) – The policy applies only to packets whose source port
numbers are less than those in the specified range.
•
gt(3) – The policy applies only to packets whose source port
numbers are greater than those in the specified range.
•
range(4) – The policy applies to packets whose source port
numbers fall within the specified range.
•
undefined(7)
snAgAclSourceOperand1
brcdIp.1.2.2.15.2.1.9
Syntax: Integer Read-write Applies only to TCP or UDP ports in extended ACLs.
Shows the source port number to be matched. If used with the
“snAgAclSourceOperand2” object, it defines the start of the range of
source port numbers to be matched.
Valid values: 0 – 65535. A value of 0 means that this object is not
applicable.
snAgAclSourceOperand2
brcdIp.1.2.2.15.2.1.10
Syntax: Integer Read-write Applies only to TCP or UDP ports in extended ACLs.
Used with the
“snAgAclSourceOperand1” object, it defines the end of the
range of source port numbers to be matched.
Valid values: 0 – 65535. A value of 0 means that this object is not
applicable.
Use this object to identify the ICMP message type number. Make sure
you indicate a code number in the
“snAgAclIcmpCode” object.
Valid values for ICMP type number are:
•
0 = not applicable
•
1 = Echo reply
•
4 = Destination unreachable
•
5 = Source quench
•
6 = Redirect
•
9 = Echo request
•
10 = Router advertisement
•
11 = Router solicitation
•
12 = Time exceeded
•
13 = Parameter problem
•
14 = Timestamp request
•
15 = Timestamp reply
•
16 = Information request
•
17 = Information reply
•
18 = Address mask request
•
19 = Address mask reply
snAgAclDestinationIp
brcdIp.1.2.2.15.2.1.11
Syntax: IpAddress Read-write Applies only to extended ACLs.
Identifies the destination IP address of the packet that will either be
permitted or denied.
snAgAclDestinationMask
brcdIp.1.2.2.15.2.1.12
Syntax: IpAddress Read-write Applies only to extended ACLs.
Identifies the destination subnet mask of the packet that will either be
permitted or denied.
Name, OID, and Syntax Access Description