Brocade Virtual ADX MIB Reference (Supporting ADX v03.1.00) - Manual (Page 60)

48 Brocade Virtual ADX MIB Reference
53-1003312-01
MAC port security table
MAC port security interface MAC table
This table shows the same information as the show port security mac ethernet CLI
command.
MAC port security autosave MAC table
This table shows the same information as the show port security autosave CLI command.
Name, Identifier, and Syntax Access Description
snPortMacSecurityIntfMacTable
brcdIp.1.1.3.24.1.1.4 N/A The MAC Port Security Interface MAC table that shows the MAC
port security status for each Ethernet interface.
snPortMacSecurityIntfMacEntry
brcdIp.1.1.3.24.1.1.4.1 N/A An entry in the MAC Port Security Interface MAC table.
snPortMacSecurityIntfMacIfIndex
brcdIp.1.1.3.24.1.1.4.1.1
Syntax: Integer Read only An entry in the MAC Port Security Interface MAC table, showing
the ifIndex value of the local interface.
snPortMacSecurityIntfMacAddres
s
brcdIp.1.1.3.24.1.1.4.1.2
Syntax: MAC Address Read only The secure MAC addresses for this local Ethernet interface on
which the secure MAC address is configured and learned. The
maximum number of the secure MAC addresses is restricted by
the object
snPortMacSecurityIntfContentMaxLockedMacAllowed.
snPortMacSecurityIntfMacVlanId
brcdIp.1.1.3.24.1.1.4.1.3
Syntax: Unsigned32 Read-write The VLAN membership of this interface. A value of zero
indicates it is not applicable.
snPortMacSecurityIntfMacRowSt
atus
brcdIp.1.1.3.24.1.1.4.1.4
Syntax: Integer Read-write Controls the management of the table rows. The values that
can be written are:
•
delete(3) – Delete the row
•
create(4) – Create a new row
If the row exists, then a SET with a value of create(4) returns a
"bad value" error. Deleted rows are removed from the table
immediately.
The following values can be returned on reads:
•
noSuch(0) – No such row
•
invalid(1) – Row is inoperative
•
valid(2) – Row exists and is valid
Name, Identifier, and Syntax Access Description
snPortMacSecurityAutosaveMac
Table
brcdIp.1.1.3.24.1.1.5 N/A The MAC Port Security Autosave MAC table that shows the secure
MAC addresses that were saved automatically.
snPortMacSecurityAutosaveMac
Entry
brcdIp.1.1.3.24.1.1.5.1 N/A An entry in the MAC Port Security Autosave MAC table.
snPortMacSecurityAutosaveMac
IfIndex
brcdIp.1.1.3.24.1.1.5.1.1
Syntax: Integer32 Read only An entry in the MAC Port Security Autosave MAC table, showing
the ifIndex value of the local interface.