Brocade Virtual ADX MIB Reference (Supporting ADX v03.1.00) - Manual (Page 118)

106 Brocade Virtual ADX MIB Reference
53-1003312-01
Port VLAN configuration table
snVLanByPortCfgStpMaxAg
e
brcdIp.1.1.3.2.7.1.11
Syntax: Integer Read only Shows the value of dot1dStpMaxAge, which is the maximum age that
the STP information can exist before it is discarded. The STP
information is learned from the network. The value of this object is in
hundredths of a second, and is the actual value that this bridge is
currently using.
(Refer to RFC1493 Bridge MIB.)
snVLanByPortCfgStpHelloTi
me
brcdIp.1.1.3.2.7.1.12
Syntax: Timeout Read only Shows the value of dot1dStpHelloTime, which is the interval between
the transmission of Configuration bridge PDUs by this node. This value
applies to any port when it is the root of the spanning tree or is trying
to become the root. This is the actual value that this bridge is currently
using.
This value is in hundredths of a second.
(Refer to RFC1493 Bridge MIB.)
snVLanByPortCfgStpHoldTi
me
brcdIp.1.1.3.2.7.1.13
Syntax: Integer32 Read only Shows the value of dot1dStpHoldTime, which is the interval when no
more than two Configuration bridge PDUs shall be transmitted by this
node. The interval is in units of hundredths of a second.
(Refer to RFC1493 Bridge MIB.)
snVLanByPortCfgStpForwar
dDelay
brcdIp.1.1.3.2.7.1.14
Syntax: Timeout Read only Shows the value of dot1dStpForwardDelay, which controls how fast a
port changes its spanning state when moving towards the forwarding
state. The value determines how long the port stays in each of the
listening and learning states, which precede the forwarding state. This
value is also used, when a topology change has been detected and is
underway, to age all dynamic entries in the forwarding database.
NOTE: This value is the one that this bridge is currently using in
contrast to dot1dStpBridgeForwardDelay, which is the value
that this bridge and all others would start using should this
bridge become the root.
This value is measured in hundredths of a second.
(Refer to RFC1493 Bridge MIB.)
snVLanByPortCfgStpTimeSi
nceTopologyChange
brcdIp.1.1.3.2.7.1.15
Syntax: Time ticks Read only Shows the time since the last topology change was detected by the
bridge entity. This time is in hundredths of a second.
snVLanByPortCfgStpTopCha
nges
brcdIp.1.1.3.2.7.1.16
Syntax: Counter32 Read only Shows the total number of topology changes detected by this bridge
since the management entity was last reset or initialized.
snVLanByPortCfgStpRootCo
st
brcdIp.1.1.3.2.7.1.17
Syntax: Integer32 Read only Shows the value of dot1dStpRootCost, which is the cost of the path to
the root as seen from this bridge.
(Refer to RFC1493 Bridge MIB.)
snVLanByPortCfgStpRootPo
rt
brcdIp.1.1.3.2.7.1.18
Syntax: Integer32 Read only Shows the value of dot1dStpRootPort, which is the port number of the
port which offers the lowest cost path from this bridge to the root
bridge.
(Refer to RFC1493 Bridge MIB.)
Name, OID, and Syntax Access Description