Brocade Virtual ADX MIB Reference (Supporting ADX v03.1.00) - Manual (Page 79)

Brocade Virtual ADX MIB Reference 67
53-1003312-01
Packet port information table
Packet port information table
Packet over SONET (POS) is the serial transmission of data over SONET frames through the use of
Point-to-Point Protocol (PPP). The POS modules allow direct connection to interfaces within SONET.
POS is a transport technology that encapsulates packet data such as an IP datagram directly into
SONET.
The POS modules are available on the Internet Backbone routers and Layer 3 Switches with
redundant management modules.
The following table presents information about POS ports.
Name, OID, and Syntax Access Description
snPOSInfoTable
brcdIp.1.2.14.1.1 None POS Port Information table.
snPOSInfoEntry
brcdIp.1.2.14.1.1.1 None An entry in the POS Port Information table.
snPOSInfoPortNum
brcdIp.1.2.14.1.1.1.1
Syntax: Integer Read only The chassis slot and port number.
•
Bit 0 to bit 7 – port number.
•
Bit 8 to bit 11 – slot number (for chassis devices only).
snPOSIfIndex
brcdIp.1.2.14.1.1.1.2
Syntax: Integer Read only Identifies the instance of the ifIndex object as defined in RFC 1213
and RFC 1573.
snPOSDescr
brcdIp.1.2.14.1.1.1.3
Syntax: DisplayString Read only Description of the chassis slot and port.
snPOSName
brcdIp.1.2.14.1.1.1.4
Syntax: DisplayString Read-write Name of the port.
Valid values: Up to 255 characters.
snPOSInfoSpeed
brcdIp.1.2.14.1.1.1.5
Syntax: Integer Read-write The bandwidth of the interface, which can be one of the following:
•
s155000(1) bps
•
s622000(2) bps
•
other(3)
•
s2488000(4) bps
snPOSInfoAdminStatus
brcdIp.1.2.14.1.1.1.6
Syntax: Integer Read-write The desired state of the interface, which can be one of the
following:
•
up(1) – The port is ready to pass packets.
•
down(2) – The port is not ready to pass packets.
•
testing(3) – The port is in test mode. No packets can be
passed.
snPOSInfoLinkStatus
brcdIp.1.2.14.1.1.1.7
Syntax: Integer Read only The current operational state of the link, which can be one of the
following:
•
up(1) – The port is ready to pass packets.
•
down(2) – The port is not ready to pass packets.
•
testing(3) – The port is in test mode. No packets can be
passed.