Brocade Virtual ADX MIB Reference (Supporting ADX v03.1.00) - Manual (Page 230)

218 Brocade Virtual ADX MIB Reference
53-1003312-01
Monitor groups
snL4VirtualServerPortHistoryCont
rolBucketsRequested
brcdIp.1.1.4.28.7.1.3
Syntax: Integer Read-write The requested number of data samples that will be saved for
this entry. The number of actual samples saved in the
“snL4VirtualServerPortHistoryControlBucketsGranted” object
should be close to the value of this object. If the value of this
object is modified, then the value of the
“snL4VirtualServerPortHistoryControlBucketsGranted” object
will be adjusted according to the new value of this object.
Valid values: 1 – 65535
Default: 50
snL4VirtualServerPortHistoryCont
rolBucketsGranted
brcdIp.1.1.4.28.7.1.4
Syntax: Integer Read only The number of data samples that was actually saved for this
entry.
If the value of the
“snL4VirtualServerPortHistoryControlBucketsRequested” object
is modified, then the actual number of samples saved by this
object will be adjusted accordingly.
If all the requested buckets are filled, a new bucket will be
added to the table, and the oldest bucket for the entry will be
deleted.
If the value of this object changes to a value less than the
current value, enough of the oldest entries will be deleted so
that the number of buckets does not exceed the new value of
this object.
If the value of this object changes to a value greater than the
current value, the number of buckets will increase but will not
exceed the new value of this object.
snL4VirtualServerPortHistoryCont
rolInterval
brcdIp.1.1.4.28.7.1.5
Syntax: Integer Read-write Shows the interval, in seconds, over which the data is sampled
for each bucket.
NOTE: A counter for a bucket may overflow without any
indication; therefore, be sure to account for the overflow
in all the counters you configure. Consider the minimum
time it takes for a counter to overflow and set this object
(snL4VirtualServerPortHistoryControlInterval) to a value
less than the overflow interval. This is especially
important for the “octets” counter in any data-source
table.
You cannot modify the value of this object if the value of this
entry’s
“snL4VirtualServerPortHistoryControlStatus” object is
equal to valid(1).
Valid values: 1 – 3600 seconds
Default: 1800 seconds
snL4VirtualServerPortHistoryCont
rolOwner
brcdIp.1.1.4.28.7.1.6
Syntax: DisplayString Read-write The administrator who owns or configured this entry.
snL4VirtualServerPortHistoryCont
rolStatus
brcdIp.1.1.4.28.7.1.7
Syntax: Integer Read-write The state of this entry:
•
valid(1)
•
createRequest(2)
•
underCreation(3)
•
invalid(4) – This entry will be deleted from the table if its
state changes to this state.
Name, OID, and Syntax Access Description