Brocade Virtual ADX MIB Reference (Supporting ADX v03.1.00) - Manual (Page 260)

248 Brocade Virtual ADX MIB Reference
53-1003312-01
Objects for traps
Trap receiver table (IPv4)
This table allows you to configure trap receivers on IPv4 devices.
Name, OID, and Syntax Access Description
snAgTrpRcvrCurEntry
brcdIp.1.1.2.1.16
Syntax: Integer Read only Shows the total number of entries that are currently in the
Trap Receiver Table. There can be up to 255 entries.
snAgGblTrapMessage
brcdIp.1.1.2.1.44
Syntax: DisplayString Read only Shows a generic trap message.
Name, OID, and Syntax Access Description
snAgTrpRcvrTable
brcdIp.1.1.2.3.1 None The Trap Receiver Table
snAgTrpRcvrEntry
brcdIp.1.1.2.3.1.1 None A row in the Trap Receiver Table. The column “snAgTrpRcvrStatus” is used to
create and delete rows in the table. Creation requires a SET PDU with objects
snAgTrpRcvrIndex, snAgTrpRcvrIpAddr, snAgTrpRcvrCommunityOrSecurityName
and snAgTrpRcvrStatus.
snAgTrpRcvrIndex
brcdIp.1.1.2.3.1.1.1
Syntax: Integer32 Read
only Shows the index in the Trap Receiver Table.
Valid values: 1 – 10
snAgTrpRcvrIpAddr
brcdIp.1.1.2.3.1.1.2
Syntax: IpAddress Read-
write Indicates the IP address of the SNMP manager that will receive the trap.
snAgTrpRcvrCommuni
tyOrSecurityName
brcdIp.1.1.2.3.1.1.3
Syntax: OctetString Read-
write Indicates the community string to use to access the trap receiver. This object can
have up to 32 octets.
snAgTrpRcvrStatus
brcdIp.1.1.2.3.1.1.4
Syntax: Integer Read-
write Controls the management of the table rows. The values that can be written are:
•
ignore(5) – Do not send traps to this entry at this time
•
delete(3) – Delete the row. (See note below regarding deleting a trap
receiver.)
•
create(4) – Create a new row
If the row exists, then a SET with a value of create(5) returns error "badValue".
Deleted rows are deleted immediately.
The following values can be returned on reads:
•
other(1) – Some other case
•
valid(2) – Row exists and is valid
•
ignore(5) – Do not send traps to this entry at this time
snAgTrpRcvrUDPPort
brcdIp.1.1.2.3.1.1.5
Syntax: Integer Read-
write Indicates the UDP port number of the trap receiver.
Valid values: 0 – 65535
Default: 162